| There could be many reasons for which the radio | | | | engine, setting parking brake, and the battery |
| quit working. When this occurs, it is necessary for | | | | disconnected are done. All these steps are done to |
| the radio to be replaced. The first thing that has to | | | | prevent any form of short circuiting till this thing is |
| be done to replace the old radio is to remove it. | | | | done. After the precautionary steps are done, the |
| After the removal is done, the connections of the | | | | trim panel of the vent is pried up. This can be done |
| new radio must be done to the already existing | | | | with the help of the panel tool. It is a long panel is |
| connectors. Hence this is not very difficult. And the | | | | found above the dash. It has the vents of the air |
| following directions on how to install a jeep wrangler | | | | conditioner and the heaters. Now the trim panel that |
| radio are pretty easy. | | | | is around the speaker is seen. |
| For doing this task, a screwdriver, wrench and a | | | | The screws at the edge on top of the trim panel of |
| panel tool are required. The following steps are to be | | | | the receiver are removed. These in turn were |
| done carefully with little precaution. The compact | | | | exposed when the trim panel was removed. The trim |
| discs or other cassettes are to be removed from | | | | panel that surrounds the receiver is pried off. This |
| the old radio. Other precautions like switching off the | | | | can be done by using the panel tool. |